HCF calculator

Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield Calculator

Engineering Chemistry Financial Health More >>

↳

Civil Chemical Engineering Electrical Electronics More >>

⤿

Engineering Hydrology Bridge and Suspension Cable Coastal and Ocean Engineering Columns More >>

⤿

Groundwater Hydrology Abstractions from Precipitation Area, Velocity and Ultrasonic Method of Streamflow Measurement Discharge Measurements More >>

⤿

Recharge Aquifer Analysis and Properties Coefficient of Permeability Confined Groundwater Flow between Water Bodies More >>

⤿

Estimation of Recharge

⤿

Specific Yield Method Groundwater Level Fluctuation Rainfall Infiltration Method

⤿

Maximum Value of Specific Yield for Various Hydrogeologic Conditions based on Norms Minimum Value of Specific Yield for Various Hydrogeologic Conditions based on Norms Recommended Value of Specific Yield for Various Hydrogeologic Conditions based on Norms

✖The Water Level Fluctuation refers to the irregular rising and falling in number or amount of water during monsoon season.ⓘ Water Level Fluctuation [h]			+10% -10%
✖The Watershed Area refers to the isolated area with a well demarcated boundary line, draining the rainwater to a single outlet.ⓘ Watershed Area [A]			+10% -10%
✖The Gross Water Draft refers to the total volume of water extracted or utilized from a catchment area.ⓘ Gross Water Draft [D_G]			+10% -10%

✖The Possible Recharge refers to the gross recharge minus the natural recharge of the area.ⓘ Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield [R]

⎘ Copy

👎

Formula

LaTeX

Reset

👍

Download Engineering Hydrology Formula PDF PDF Image

Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield Solution

STEP 0: Pre-Calculation Summary

Formula Used

Possible Recharge = (0.5*Water Level Fluctuation*Watershed Area)-Gross Water Draft
R = (0.5*h*A)-D_G
This formula uses 4 Variables

Variables Used

Possible Recharge - (Measured in Cubic Meter per Second) - The Possible Recharge refers to the gross recharge minus the natural recharge of the area.
Water Level Fluctuation - (Measured in Meter) - The Water Level Fluctuation refers to the irregular rising and falling in number or amount of water during monsoon season.
Watershed Area - (Measured in Square Meter) - The Watershed Area refers to the isolated area with a well demarcated boundary line, draining the rainwater to a single outlet.
Gross Water Draft - (Measured in Cubic Meter per Second) - The Gross Water Draft refers to the total volume of water extracted or utilized from a catchment area.

STEP 1: Convert Input(s) to Base Unit

Water Level Fluctuation: 5 Meter --> 5 Meter No Conversion Required
Watershed Area: 20 Square Meter --> 20 Square Meter No Conversion Required
Gross Water Draft: 10 Cubic Meter per Second --> 10 Cubic Meter per Second No Conversion Required

STEP 2: Evaluate Formula

Substituting Input Values in Formula

R = (0.5*h*A)-D_G --> (0.5*5*20)-10

Evaluating ... ...

R = 40

STEP 3: Convert Result to Output's Unit

40 Cubic Meter per Second --> No Conversion Required

FINAL ANSWER

40 Cubic Meter per Second <-- Possible Recharge

(Calculation completed in 00.004 seconds)

You are here -

Home » Engineering » Civil » Engineering Hydrology » Groundwater Hydrology » Recharge » Estimation of Recharge » Specific Yield Method » Maximum Value of Specific Yield for Various Hydrogeologic Conditions based on Norms » Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield

Credits

Created by Mithila Muthamma PA

Coorg Institute of Technology (CIT), Coorg

Mithila Muthamma PA has created this Calculator and 2000+ more calculators!

Verified by Chandana P Dev

NSS College of Engineering (NSSCE), Palakkad

Chandana P Dev has verified this Calculator and 1700+ more calculators!

< Maximum Value of Specific Yield for Various Hydrogeologic Conditions based on Norms Calculators

Possible Recharge in Sandy Alluvial Areas for Maximum Value of Specific Yield

LaTeX Go Possible Recharge = (20*Water Level Fluctuation*Watershed Area)-Gross Water Draft

Possible Recharge in Silty Alluvial Areas for Maximum Value of Specific Yield

LaTeX Go Possible Recharge = (12*Water Level Fluctuation*Watershed Area)-Gross Water Draft

Possible Recharge in Hard Rock Areas with Low Clay Content for Maximum Value of Specific Yield

LaTeX Go Possible Recharge = (4*Water Level Fluctuation*Watershed Area)-Gross Water Draft

Possible Recharge in Clayey Alluvial Areas for Maximum Value of Specific Yield

LaTeX Go Possible Recharge = (8*Water Level Fluctuation*Watershed Area)-Gross Water Draft

Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield Formula

LaTeX Go

Possible Recharge = (0.5*Water Level Fluctuation*Watershed Area)-Gross Water Draft
R = (0.5*h*A)-D_G

What is Recharge in Hydrology?

Groundwater Recharge or deep drainage or deep percolation is a hydrologic process, where water moves downward from surface water to groundwater. Recharge is the primary method through which water enters an aquifer.

How to Calculate Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield?

Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield calculator uses Possible Recharge = (0.5*Water Level Fluctuation*Watershed Area)-Gross Water Draft to calculate the Possible Recharge, The Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield is defined for the specific region of consideration based on the value of recommended norms for specific yield in percentage. Possible Recharge is denoted by R symbol.

How to calculate Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield using this online calculator? To use this online calculator for Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield, enter Water Level Fluctuation (h), Watershed Area (A) & Gross Water Draft (D_G) and hit the calculate button. Here is how the Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield calculation can be explained with given input values -> 40 = (0.5*5*20)-10.

FAQ

What is Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield?

The Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield is defined for the specific region of consideration based on the value of recommended norms for specific yield in percentage and is represented as R = (0.5*h*A)-D_G or Possible Recharge = (0.5*Water Level Fluctuation*Watershed Area)-Gross Water Draft. The Water Level Fluctuation refers to the irregular rising and falling in number or amount of water during monsoon season, The Watershed Area refers to the isolated area with a well demarcated boundary line, draining the rainwater to a single outlet & The Gross Water Draft refers to the total volume of water extracted or utilized from a catchment area.

How to calculate Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield?

The Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield is defined for the specific region of consideration based on the value of recommended norms for specific yield in percentage is calculated using Possible Recharge = (0.5*Water Level Fluctuation*Watershed Area)-Gross Water Draft. To calculate Possible Recharge in Hard Rock Areas with Massive, Poorly Fractured Rock for Maximum Specific Yield, you need Water Level Fluctuation (h), Watershed Area (A) & Gross Water Draft (D_G). With our tool, you need to enter the respective value for Water Level Fluctuation, Watershed Area & Gross Water Draft and hit the calculate button. You can also select the units (if any) for Input(s) and the Output as well.

How many ways are there to calculate Possible Recharge?

In this formula, Possible Recharge uses Water Level Fluctuation, Watershed Area & Gross Water Draft. We can use 3 other way(s) to calculate the same, which is/are as follows -

Possible Recharge = (20*Water Level Fluctuation*Watershed Area)-Gross Water Draft
Possible Recharge = (12*Water Level Fluctuation*Watershed Area)-Gross Water Draft
Possible Recharge = (8*Water Level Fluctuation*Watershed Area)-Gross Water Draft

Home

FREE PDFs

🔍 Search